CAMOUFLAGE PRODUCTS

Pine Tree

This Tree Mast resembles an evergreen conifer and uses pine needles as opposed to leaves. Should you need to perform maintenance, the tree contains an internal caged ladder, which leads onto a working platform at the top of the Mast.

Palm Tree 

This is a highly versatile, multi-carrier camouflaged structure. Should you need to perform maintenance, the tree contains doors at the bottom and top of the Mast and an internal ladder. It’s best suited for temperate, subtropical and tropical environments.

Yellowwood Tree 

As the national tree of South Africa, it’s no wonder that our Yellowwood Tree Mast is a firm favourite. In fact, it’s so popular that we designed a low-cost, low profile solution for operators.  

Textile Surface Manipulation, incorporating a combination of special colourants and coatings, is used to create the tree’s lifelike and durable bark, which is applied to the steel trunk. It’s best suited for application in most areas in South Africa.

Ana Tree 

This thorny tree resembles a Yellowwood; however, the branches are entirely different, evident in the installation of the tree branches. Textile Surface Manipulation, incorporating a combination of special colourants and coatings, is used to create the Ana tree’s lifelike and durable bark, which is applied to the steel trunk.

Cypress Tree

The Cypress Tree Mast is a flame-shaped, tapering cone-like tree, with a very short trunk visible below its branches. The branches form frond-like sprays with small overlapping leaves which are smooth and shiny shades of green. It’s best suited for Mediterranean and coastal regions, and we adhere to the appropriate structural design codes of these areas.

Rooftop Shrub

Rooftop shrubs, which look a lot like a miniature pine tree, give urban buildings an environmentally-friendly appearance. While antenna poles and antennas can be rather unsightly, the smooth, needle-shaped design of the rooftop shrubs’ leaves and its ability to realistically sway in the wind make it an attractive and functional addition to any space.

 -    Heights range from 2 – 6m

-    Space for two internal antennas

-    Potential to add an MW dish

-    Best suited for densely populated urban areas

Billboard

Our highly aerodynamic billboards provide an ideal surface for signage and advertising while reducing the drag coefficient of the mast. The cellular and microwave antennae mounting is housed behind specially designed and manufactured cladding panels, effectively camouflaging it. This triangular steel structure is clad with RF transparent panels on the top section and multi-customer advertising panels beneath. An internal caged ladder opens onto platforms at each advertising panel level where the antennae are mounted.